WallWizard X700CB Manual - Manual (Page 7)

www.closystems.com 7
Set
Power
switch
Do not use.
(incorrect)
Use this width.
(correct)
5. Set the X-arm™ TV width
It is important to set the correct TV width on X-arm™ to avoid injury or property damage. The X-
arm™ restricts movement based upon the TV width that is set.
5-1. Attach the power cord and connect the X-arm™ to a grounded power
outlet. The X-arm™ power cord has a grounding conductor grounding
plug. The plug must be plugged into an appropriate outlet with 3 prongs
that is properly installed and grounded in accordance with all local
codes and ordinances. See the front of this manual for more grounding
instructions.
5-2. Press the power switch to ON (1).
IMPORTANT: Do not operate the X-arm by
using the remote control at this time.
5-3. Measure the total width of the TV including any
side speakers that may be attached to the TV.
Do not use the TV manufacturer’s screen size,
which is measured diagonally, to set the TV
width on X-arm™.
5-4. Insert the provided plastic pointer into the Selector hole, and
press the button until the TV width code corresponds to the
outside width of your TV as indicated in the table below.
Code TV Outside Width
C1 40” - 44.9” (102 - 113 cm)
C2 45” - 48.9” (114 - 123 cm)
C3 49” - 55.9” (124 - 140 cm)
C4 56” - 63.0” (142 - 160 cm)
5-5. Hold the black rubber Set button, below the selector hole, until the TV
width code stops blinking.
5-6. Attach the IR receiver.
5-7. Optional (X700CS & CB Models only): To control X-arm™ with home
automation through the RJ11/RS232 port, see page 22 for instructions.
. Remove the TV Mounting Brackets
6-1. Extend X-arm™ straight out from the
wall by pressing the MOUNT button
and then the OUT button on the
remote once while aiming at the IR
Receiver.
6-2. Remove the hex screws from the
ends of the TV Mounting Brackets
with the provided hex wrench.
6-3. Pull the Safety Clips from the backs
of the TV Mounting Brackets, and
then remove the TV Mounting
Brackets.
6-4. Save all the removed pieces.
Safety
Clips