WallWizard X700CB Manual User Manual

Page 14

www.closystems.com

Using X-arm™

Setting X-arm™ TV width

NOTE: Do not repeat setting the width if you finished step 5 in the installation portion of this manual.

Caution: X-arm™ restricts movement based upon the TV width selected by the user. The TV width

must be set correctly before operating X-arm™. Setting the incorrect width may result in property

damage and/or injury.

1. Plug in X-arm™.

2. Press the power switch on the side of X-arm™ to “1” (ON).

3. Measure the total width of the TV including any side speakers that may be attached

to the TV.

4. Insert the provided plastic pointer into the Selector hole, and press the button until the

TV width code corresponds to the outside width of your TV as indicated in the table

below.

Code TV Outside Width__

40” - 44.9” (102 - 113 cm)

45” - 48.9” (114 - 123 cm)

49” - 55.9” (124 - 140 cm)

56” - 63.0” (142 - 160 cm)

5. Hold the black rubber Set button, below the Selector hole, until the TV width code

stops blinking.

6. X-arm™ will restrict the movement of the TV based upon the TV width selected.

Adjusting the TV position

Before using X-arm™, it is important that the correct TV width is set to avoid property damage or personal

injury. See the “Setting X-arm™ TV Width section above to set the correct TV width. Keep everything and

everyone away from X-arm™ while in motion. The user must observe the X-arm™ while it is in motion at

all times until it is stopped by pressing one of the directional arrows on the remote control.

1. With X-arm™ plugged in, press the POWER switch on the control box to “1” (ON).

2. On the remote, first push MOUNT . X-arm™ is now ready to receive control signals from the

remote control.

3. If the TV width code is not displayed on the control box, press mount then power on the remote.

Then press OUT once to extend the TV out from the wall. There is no need to hold down the

button. Pressing any of the arrow buttons while X-arm™ is moving the TV will stop it.

4. On the remote, press one of the four (4) arrow keys to start X-arm™ swiveling or tilting in the

direction selected. Press any of the four arrow keys or IN or OUT to stop X-arm™ from moving

the TV.

5. Press IN once to send X-arm™ back to the resting/home position, which will retract the TV

against the wall.

6. Once the preset buttons have been set, press the P1 or P2 (Model X700RS & RB) or P1, P2,

P3 or P4 (Model X700CS & CS) to go to pre-programmed positions (see “Programming X-

arm™ Preset Position Buttons”).

Set