WallWizard X700CB Manual - Manual (Page 13)

www.closystems.com 13
12. Attach IR Receiver to TV
12-1. Using the provided velcro tab, adhere the IR receiver eye-piece to the TV so it has a
clear line of sight with the remote control.
13. Calibrate X-arm™ to Your TV
IMPORTANT: X-arm™ must be calibrated to the TV to avoid hitting the wall.
13-1. Switch off the main power on the control box of X-arm™.
13-2. Hold down the set button on the control box while switching on the
power. Continue holding down the Set button for 5 seconds until the
display reads CT.
13-3. Stand back while X-arm™ moves through the calibration sequence,
moving in and out, left and right and up and down.
13-4. X-arm™ is done calibrating when it goes back to the home position
against the wall.
13.5 If the TV is not parallel with the wall in the home position, you can
reset the home position so that the TV is upright. To do this, go to
step 14.
14. Reset the home position of X-arm (optional)
14-1. Move X-arm to the home position, against the wall, by pressing the IN button on the
remote once.
14-2. Insert the provided plastic pointer into the Selector hole on the side of the X-arm control
box and press the button until the display reads HP.
14-3. Using the up and down arrow buttons on the remote, adjust the X-arm to the position
where you want the TV when it is in “home” position.
14-4. Press the Set button on the side of the X-arm for 3 seconds.
14-5. The X-arm will now go to the new home position you just programmed every time you
select the IN button for it to go home.
Set
13-1
13-2