WallWizard X700CB Manual - Manual (Page 5)

www.closystems.com 5
Installing X-arm™
For concrete wall installation, go to the “Concrete Wall Installation” section. For wood stud wall
installation continue below.
Tools Needed
Wood Stud Wall Installation
1. Locate wall studs
1-1.Using a stud finder, locate two wooden studs no
more than 17” (43,18 cm) apart, center to center.
1-2. Mark the stud centers on the wall.
To avoid property damage or injury, the mount must
attach to at least two 2” x 4” (51 x 102 mm) wood
studs.
2. Drill mounting holes
2-1. Remove the wall plate from the back of the X-arm™. First loosen the 2 security screws
at the bottom, then lift the wall plate off the X-arm™.
2-2. Hold the wall plate up to the wall so that the
mounting holes line up with studs.
2-3. Level the wall plate.
2-4. Mark the 6 places where the wall plate holes line
up with the wall studs.
2-5. Remove the wall plate, then drill 6 holes with a
1/8” (3mm) drill bit, 2-1/2” (6,35 cm) deep at the
locations drawn from step 2-4. 2”x 4” (51 x 102 mm)
Wood Studs
Level Philips screw
driver
Adhesive tape
3/8” (9.5 mm)
wrench
Socket wrench
(optional)
Stud finder Hammer Drill with 1/8” (3mm) bit
(Wood stud wall)
Masonry bit (Concrete wall)