WallWizard X700CB Manual User Manual

Page 23

www.closystems.com

Troubleshooting

X-arm™ Will Not Move

If X-arm becomes unresponsive, first check to see what the LED display on the side of the X-

arm control reads. Then choose a course of action based upon the code.

“A1”, “A2”, or “A3” is displayed on control box
Possible Causes:

One of the motor cables is disconnected.

One of the “stop” sensors is disconnected, misaligned or broken.

One of the long drive screws is dirty.

A motor coupling is loose.

How to Correct:

1. Unplug X-arm

™

from power for at least 10 seconds.

2. Check that the TV and X-arm

™

are not trapped against the

wall or any other object.

3. Plug in X-arm

™,

turn on the power and try to move the X-

arm

™

using the remote control. If it works properly, do not

continue to step 4.

4. With the X-arm

™

powered on, insert the provided plastic

pointer in the Selector hole on the side of the X-arm

™

and

press it until “t” shows on the LED display.

5. Using the remote control, straighten X-arm

™

so that it is

parallel with the wall, and then press the “Set” button on the

control box for three seconds. The X-arm

™

should return to

the home position against the wall.

6. Unplug X-arm

™

from power for at least 10 seconds and then plug it in again. Turn on the

power and try to move the X-arm

™

using the remote control. Continue to the next step if

it does not work correctly.

7. Unplug the X-arm

™

from power.

8. Remove the TV and inspect the areas in the

picture corresponding to the error message. For

example, if A3 is displayed on the LED, look at

areas in the A3 box. Make sure that all motor

and “stop” switch wire connections are securely

connected.

9. Check to see that the wires leading to the control

box are securely connected.

10. Clean any substances or particles from the long drive screws.

11. Plug in X-arm™, turn on the power and try to move the X-arm

™

using the remote

control.

•

Set

Power Switch

Control Box

LED Display

Selector

Set Button

motor

control box wires

switch switch

switch