WallWizard X700CB Manual - Manual (Page 12)

12 www.closystems.com
2
1
Top Bar
TV Mounting
Bracket
Hex Wrench
Hex Screw
Safety
Clips
11-1
11-3
TV Mounting
Brackets
Hook End
9. Attach mounting brackets to the TV
9-1. Place the TV Mounting Brackets on the TV lined up
with the mounting holes so that the hook is on the top.
9-2. Using a washer, lock washer and then a bolt, attach
the brackets securely to your TV. Use the bolts that
came with your TV if possible. If this is not possible,
select hardware from those supplied. Bolts must
match your TV manufacturer’s recommendations or
else they can not be used.
Although a philips screw driver is pictured, some
specialized TV screws require the special hex wrench
provided with the screw packet.
10. Hang the TV on X-arm™
!
Caution: The TV is very heavy. Use at least two people to hang the TV on X-arm™.
10-1. Hang the TV on the top bar of X-arm™ and then carefully rotate it down.
11. Attach the safety clips
11-1. Insert the two safety clips on to the top of
the TV Mounting Brackets and secure them
using the included hex wrench.
11-2. Continue running the cables to the TV. The
TV may need to be tilted out on the bottom,
especially if connectors are toward the
center of the TV. If the TV needs to be tilted,
have one person carefully tilt the TV out
from the bottom and another person run the
cables.
11-3. After the cables have been connected,
secure the bottom safety clips to the bar.