Visara Master Console Center Installation - Manual (Page 17)

Chapter 2 Site Preparation and Installation Overview
Installation Preparation Guide 17
Site Installation
Site installation activities listed below are principally the responsibility of
the customer; Visara will assist where appropriate.
Power installation (Chapter 3 Power Requirements)
ƒ Run the appropriate service to the MCC server installation location.
Cable installation.
Note: This is not a complete list, see Chapter 4 MCC Network and
Chapter 5 Connectivity Interfaces for more details.
ƒ Run coax cable from each controller (3174 or other) port to the MCC
rack installation location.
ƒ Enable the MCC’s IP address for remote client support on all HMCs.
ƒ Run network cable from the appropriate systems (or a drop from the
corporate network) to the MCC server installation location for
telnet/VT100 access.
ƒ Connect MCC to Network. Depends on network design decisions. Final
requirement is Ethernet access from each Thin Client / workstation to
the MCC server.
ƒ Install analog phone line for the modem and phone.