Verilink AS56/56Plus (896-502588-001) Product Manual - Manual (Page 85)

Terminal Operation
AS56 and AS56 Plus User Manual 6-7
Terminal Operation
Because the terminal functions are identical to the front panel functions
previously described in this manual (except for a more comprehensive
display), their descriptions are not repeated here. Instead, screen displays
for the T1 ESF CSU and the DDS 56/64 kbps CSU are shown, beginning
with the Main Menu below. The user is advised to peruse the CRT menus
while reviewing the front panel descriptions. In all cases,
SPACE
advances the cursor, BS moves the cursor back, ENTER or RETURN
selects an entry, and ESC acknowledges an alarm.
Selecting the
operating mode If you have purchased the AS56 Plus unit, you can select one of two
network interface operating modes: T1/FT1 mode or 56/64 kbps DDS
mode. Changing the operating mode can only be accomplished by using
the ASCII console interface. Select the mode as follows:
Add 1 screen
==>
**** ****
**** **** T-1 ESF CSU/DSU MAIN MENU
**** ****
**** **** System Configuration
**** **** Serial Port Diagnostics/Indicator
***** **** System Alarms and Statistics
**** **** ESF Registers
**** **** Event Log
******** System Utilities
******
Cursor Forward = [SPACE]
Verilink Corporation Cursor Back = [BS]
AS56 Plus T-1 CSU/DSU Select Entry = [ENTER]
Software: S:1.18 X:423438 Acknowledge Alarm = [ESC]
Deactivate Console = [X]
April 26, 1996 14:30:05 Hangup Modem = [Ctrl-E]
Unit ID........: 01234567
Front Panel: ENABLED
System Status..: *****NTWK ALARM*****K