Verilink AS56/56Plus (896-502588-001) Product Manual - Manual (Page 32)

Configuring and Installing the Access Syste m56
3-8 AS56 and AS56 Plus User Manual
14. Network Scrambler. This entry enables the unit to avoid inadvertent
transmission of network loopback latching codes. The scrambler
option is only needed in 64 kbps mode, and if enabled, must be
enabled on both the local Access Syste m56 and the remote Access
System 56 units. Depress
SELECT to choose between Yes and No.
15. Network DTE LOS (Loss of Signal). This entry determines which
control signal forces the unit into a LOS state. When a LOS state
occurs, the Access Sys tem56 unit will continuously transmit the
Control Mode Idle (CMI) code to the network. Depress
SELECT to
choose between RTS, DTR and None.
Step 16 applies to both the T1 and DDS modes.
16. Timing Source. Depress SELECT to choose NI, Port 1, or Int.
As a 56/64 kbps CSU/DSU, ALL units must use NI timing.
NI Configuration
DTE LOS:_RTS
DOWN to
display:
NOTE
Configuration
_NI Interface
END to display:
Configuration
_Timing Source
DOWN to
display:
Timing Source
Source:_Int
SELECT to
display: