Tri Tool 614RBL Thru 636RBL Clamshells - Manual (Page 5)

5
Model 614RBL thru 642RBL Clamshells
92-0480 : Rev. 130916
2.6 TOOL CARE
• Keep tools in good operating condition. Sharp tool bits perform better and safer
than dull tool bits.
• Do not use damaged tools. Always check your tools for damage especially if a
tool has malfunctioned, been dropped or hit, check it for damage.
• Before you start operating the equipment, do no-load tests and feed function
checks.
WARNING
WARNING: The movement of one or both sides of a poorly secured
pipe, after a cut, could result in death or serious injury.
CAUTION: ELECTRIC MOTORS
Only use the recommended AC voltage power sources.
Observe all electric shock hazard procedures.
Do the following to reduce the risk of damage to the power and
control cords:
• Do not pull or run over the cords or the cables.
• Keep all control and power cords away from fluids and water .
CAUTION
CAUTION: HYDRAULIC DRIVES
Do not touch the components of hydraulic systems, except for the
controls during and after equipment operation. The hydraulic system
can get hot enough to cause burns. Wait for the equipment to cool
down before handling.
Do not damage the hydraulic lines.
Keep quick-disconnects clean because grit contamination causes
malfunctions and damage the equipment.
Do the following to reduce the risk of damage to the power and
control cords:
• Do not pull or run over the cords or the cables.
• Keep all control and power cords away from fluids and water.
CAUTION