Tri Tool 614RBL Thru 636RBL Clamshells User Manual

Page 29

Model 614RBL thru 642RBL Clamshells

92-0480 : Rev. 130916

6.5 INSTALLATION OF THE DRIVE MOTORS

1. Install the required Motor(s) and the Drive Housing(s), into the Slots. The

Motor Mounts react to the torque of the Motor only when the Motor Holdown

Bolts are in place.

2. Bolt the motors to the Clamshell.
3. Ensure that the Clamshell can rotate clockwise when viewed from the

Headstock front face).

4. Check that the Hydraulic motor pressure hose is connected to Port B and that

the return hose is connected to Port A.

5. Unbolt the two Red Lock Blocks attached to the headstock.
6. Flip them over.
7. Attach them with the dowel pin pointing outward. The headstock can rotate.
8. Connect the correct power supply to the Model 600RB.
9. Rotate the Headstock slowly with the Tripper Shaft pushed ‘in’ for one full

revolution to ensure that the Tripper Shaft to Sprocket is correctly aligned for

contact with the Sprocket on all Tool Blocks.

CAUTION

CAUTION: The Tripper Shaft must strike the Sprocket on the edge of

the tooth or the Clamshell can break the Tripper Shaft or the Sprocket

or both.

DANGER

DANGER: Wait for the rotating tool block to pass the tripper block

before you push the Tripper Shaft. If you hand is in the path of the

tool block before it passes the tripper block can result in serious

personal injury.

DANGER: Do not put your hands or other parts of your body on the

drive housing or the trigger bracket assembly when the head stock

is rotating Serious personal injury can occur.