Tri Tool 614RBL Thru 636RBL Clamshells - Manual (Page 32)

32
TRI TOOL INC.
92-0480 : Rev. 130916
12. Loosen the Jackscrews and the Adjustable Bars.
13. Remove the Clamshell from the pipe.
14. Unbolt the two Red Lock Blocks attached to the Headstock.
15. Flip them over and reattach them with the Dowel Pin going through the
Headstock and into the Housing.
16. The headstock is locked into place. If you need to split the Clamshell to
remove it, see Section 6.3. Ensure that the halves of the Clamshell are
supported.
ALIGNMENT
INCORRECT FOR LOCKING
CORRECT FOR LOCKING
Figure: 18. Correct and Incorrect Orientations for Locking
CAUTION
CAUTION: The Headstock must be locked in place to prevent it from
rotating out of the housing. If it rotates out of the housing it could
separate, fall on the user and cause personal injury or damage the
equipment or both.