Tri Tool 614RBL Thru 636RBL Clamshells - Manual (Page 38)

38
TRI TOOL INC.
92-0480 : Rev. 130916
6.10.3 PROCEDURE FOR LAND CUTS.
1. Loosen the Set Screws holding Tool Bits A, D and E.
2. Push Tool Bit A forward until it makes contact with the bottom of the slot.
3. Do not move Tool Bits D and E.
4. Rotate the Feed Sprocket for Tool Block No. 2 counterclockwise to bring Tool
Bits B and C into contact with the bevel they previously cut.
5. Check the Tripper Shaft to Sprocket Engagement for Tool Block No. 2.
6. Leave Tool Bits D and E in contact with the beveled surface made by Tool
Bits B and C.
7. Reconnect and power up the equipment.
8. Cut the pipe and monitor the cut of the tool bits.