Tri Tool 614RBL Thru 636RBL Clamshells User Manual

Page 35

Text mode
Original mode

Model 614RBL thru 642RBL Clamshells

92-0480 : Rev. 130916

23. Engage the Tripper Shaft by pushing it to the ‘in’ position.
24. Rotate the Headstock 360° and check the Feed Pin to Sprocket Engagement.
25. Begin to cut the pipe.
26. Loosen the Set Screws holding Tool Bits A, D and E.
27. Slide Tool Bits D and E inward until they make contact with the beveled

surface formed by Tool Bits B and C. Then ensure that Tool Bit A does not

move from its prior position.

28. Complete the preparation profile cut and first sever.

6.10

RESETTING THE TOOL BITS FOR A BLEND

A blend is required to create room for the forward edge of Tool Bits D and E.

Figure: 21.

Correct Blend

Tool Block No. 1

Correct depth of cut from Tool

Bits B and C with Tool Bits D

and E.