Tri Tool 614RBL Thru 636RBL Clamshells - Manual (Page 20)

20
TRI TOOL INC.
92-0480 : Rev. 130916
• The Drive Gears require a heavy duty grease such as “Chevron Ultra Duty NLGI
2” (P/N 68-0024).
• The Slide Rails and Tool Blocks require a light oil such as SAE 10 light machine
oil.
• The Feed Screw for the Tool Block and Tripper Block Assembly requires a SAE
10 light machine oil for normal conditions, and under dusty conditions a silicone,
graphite or molybdenum disulfide ‘dry’ lubricant.
• You can use a light film of all-purpose grease. Be sure to check it for grit
contamination.
• The Bearings in the Hydraulic Motors are sealed and do not require any
lubrication.
5.12 LUBRICANT RECOMMENDATIONS FOR AIR MOTORS
a. Air Motors require a Class 2 lubricant, viscosity of 100 to 200 SSU at 100°F
(38°C) minimum aniline point of 200°F (93°C), such as the following:
• Tri Tool Inc.. – Air Tool Lubricant (P/N 68-0022)
• Amoco – American Industrial Oil No. 32
• Atlantic Richfield – Duro Oil S–150
• Chevron – A.W. Machine Oil 32
• Exxon – Nuto H32
• Shell – Tellus Oil 32
b. The Bearings in the Air Motors are sealed and do not require additional
lubrication.
CAUTION
CAUTION: If a contaminated hydraulic fluid or if a contaminated air
supply is used, it may damage the equipment, which would void the
warranty.