Tri Tool 614RBL Thru 636RBL Clamshells - Manual (Page 37)

37
Model 614RBL thru 642RBL Clamshells
92-0480 : Rev. 130916
If the cut Tool Bits B and C made is too deep, do the following:
1. Loosen the Set Screws that hold Tool Bits A, D and E.
2. Push Tool Bit A back until it is flush with the ends of Tool Bits D and E (which
are in contact with the cut edges made by Tool Bits B and C.)
3. Tighten the Set Screws holding Tool Bits A, D and E.
4. Rotate the Feed Sprocket of Tool Block No. 2 clockwise to move the Tool
Holder away from the pipe cut so that Tool Bits B and C will not cut.
5. Pull the other Tool Bits away from the cutting surface. The only Tool Bits that
are to be cutting are Tool Bits D and E so they can catch up to the bevel
made by Tool Bits B and C.
6.10.2 PROCEDURE TO CORRECT DEEP CUTS.
Cut from Tool Bits B and C
is too deep
Tool Block No. 1
Figure: 23. Cut is too Deep
Tool Block No. 1
Figure: 24. Correcting for the Sever Tool Bit