Teac DR-40 - Manual (Page 21)

TASCAM DR-40
21
Message Meaning and response
MBR Error Init
CARD
The card is not formatted properly or the formatting is broken.
Change the card or press the ENTER/MARK button while this
message is being shown to format the card. Formatting will
erase all the data on the card.
No PB File
There is no file that can be played back. The file might be
damaged.
No MUSIC File There is no playback file, so DIVIDE cannot be executed.
Format Error
Format CARD
The card is not formatted properly or the card is broken.
This message also appears if the card was formatted using
a computer connected by USB or if an unformatted card is
inserted in the unit.
Always use the DR-40 to format cards to be used with it.
Change the card or press the ENTER/MARK button while this
message is being shown to format the card.
Formatting will erase all the data on the card.
File Not Found
Make Sys File
The system file is missing. This unit requires a system file for
operation. When this message appears, press the ENTER/
MARK button to automatically create a system file.
Invalid SysFile
Make Sys File
The system file required to operate this unit is invalid. When
this message appears, press the ENTER/MARK button to
automatically create a new system file.
Invalid Card
Change Card
Something might be wrong with the card. Change the card.
Write Timeout
Writing to the card timed out. Backup files on the card to a
computer, and format the card.
Card Full
The card has no remaining space. Erase unnecessary files or
move them to a computer to make open space.
Can't Divide
The selected division point is not suitable.
(It is too close to the beginning or end of the track.)
Max File Size
The file is larger than the designated size or the recording time
exceeded 24 hours.
File Full
The total number of folders and files exceeds 5000. Erase
unnecessary folders and files or move them to a computer.
Card Error The card could not be recognized properly. Change the card.
If any other error occurs, turn the unit off and restart it.
Messages
The following is a list of the pop-up messages.
These might appear on the DR-40 under certain conditions. Refer to this list if
one of these pop-up messages appears and you want to check the meaning or
determine a proper response.
Message Meaning and response
File Name ERR
The DIVIDE function would cause the file name to exceed 200
characters. The DIVIDE function adds “_a” or “_b” to the end of
the file name. Before choosing the DIVIDE function, connect
the unit to a computer and edit the file name to less than 198
characters.
Battery Empty The batteries are almost out of power. Replace the batteries.
No Card No card is in the unit, so recording is not possible.
File Not Found A file added to the playlist cannot be found or a file could be
damaged. Please check that file.
Non-Supported
The audio file is not a supported format. Please see “11 –
Connecting with a Computer” in the Reference Manual for file
formats that this unit can use.
File Protected The file is read only and cannot be erased.
I/O Too Short
The IN and OUT points are too close together. Set them with at
least 1 second between them.
Dup File Name
The DIVIDE function would cause the file name to be the
same as that of an existing file in the same folder. The DIVIDE
function adds “_a” or “_b” to the end of the file name. Before
choosing the DIVIDE function, connect the unit to a computer
and edit the file name.
File Not Found
PLAYLIST
A file in the Playlist cannot be found. Please confirm that the
file is still in the Music folder.
No PLAYLIST
No files have been added to the Playlist.
Add a file to the Playlist or change the play mode to something
besides PLAYLIST.
PLAYLIST Full
The playlist is full. You cannot add more than 99 tracks to the
Playlist.