Sierra Video MFC-8300 - Manual (Page 39)

MFC-8300 Series User Manual (Ver. 1.0) DashBoard Menus
• 6-3
Tab Title Item Parameters Description
Network
(Read-only)
Factory Default 2
SW3-1 and SW3-2 are set to ON. The IP
Address of the card is set to 10.1.2.1. This
is not applicable to the MFC-8320-S.
IP Address ##.#.###.### IP Address of the card
Subnet Mask ###.###.#.# Subnet Mask for the card
Default Gateway ##.#.#.# The card gateway
NTP Server ##.#.#.#
The IP Address of the NTP server used as
a time source
Active Connections ##
Number of external control devices, such as
DashBoard, connected via TCP to the card
Active Cards ##
The number of active cards within the
frame
Bus Load (%) #
Communication traffic of the CAN Bus. A
high value indicates a high amount of
traffic
Hardware
(Read-only)
Frame Status
Green – OK
Indicates the status of the frame, frame
power supplies, and/or cards in the frame
Yellow – Running a
backup code
Red – Fan door open
Red – PSU fuse
blown
Red – PSU fault
Red – Fame Power >
150W
Red – PSU fan stalled
Red – Card Fault
Mid-Plane ID #
Indicates the board issue. This field is only
displayed when using an MFC-8320-N.
Audio Alarm Enabled
Indicates that J4 is set to enable audio
alarms