Sierra Video MFC-8300 - Manual (Page 30)

4-2
• MFC-8320-N Setup
MFC-8300 Series User Manual (Ver. 1.0)
Controls for the MFC-8320-N
This section provides information on the jumpers, buttons and LEDs for the MFC-8320-N and MFC-
8320-NS. Refer to Figure 4.1 for the location of card control features such as the Alarm Mute
button, and the Alarm Config jumpers.
Figure 4.1 MFC-8320-N Card Controls
SW3 DIP Switch Settings on the MFC-8320-N
This section briefly summarizes the SW3 DIP Switch settings on the MFC-8320-N. Refer to Figure
4.1 for the location of SW3. Note that Figure 4.2 shows the DIP Switches in the ON position.
Figure 4.2 SW3 DIP Switch — Set to the ON Positions
SW3-1, SW3-2 — IP Address Setup
SW3-1 and SW3-2 are used in conjunction with the DashBoard menus to set the IP Address of the
MFC-8320-N. Refer to Table 4.1 for DIP Switch positions. For more information on configuring the
network settings for your card, refer to the section “Network Configuration.
Table 4.1 SW3-1 and SW3-2 Positions
SW3-1 Position SW3-2 Position Descriptions
OFF OFF
The card IP Address can be set by the user from the DashBoard
Network tab. This is the default setting.
OFF ON The card IP Address is automatically assigned (DHCP Mode).
ON OFF
The card IP Address is set to 192.168.2.1 The card Subnet Mask
is set to 255.255.0.0.
ON ON
The card IP Address is set to 10.1.2.1. The card Subnet Mask is
set to 255.255.0.0.