Sierra Video MFC-8300 - Manual (Page 10)

1-2
• Introduction
MFC-8300 Series User Manual (Ver. 1.0)
Features
The MFC-8300 Series Controller Cards are designed for the openGear DFR-8300 series frames and
offer a range of monitoring and control options based on the card model. The following sections outline
the features for each available MFC-8300 Series Controller Card offered by Sierra Video.
Table 1.1 Feature Comparison Chart
Features 8320-S 8320-N 8320-NS
Monitors frame power usage and sets the fan speed
accordingly
*
  
Monitors the frame door and PS-8300(s)
  
Monitors the fan door and notifies the user if it is
left open too long
  
Monitors the status of other cards in the frame via
the internal bus
  
Supports the DataSafe™ feature in DashBoard
 
Generates alarms if any of the monitored functions
develop errors
  
Provides an ethernet connection for remote control
and monitoring through DashBoard  †  
Stores the IP Address settings on the frame
  
Provides SNMP Monitoring

Supports more than one concurrent TCP Control
connections, such as DashBoard, or a control panel
 
Available for the DFR-8310 series frames
  
Available for the DFR-832x series frames
  
5-year transferable warranty
  
* Higher power consumption requires higher fan speed for adequate cooling. The fans always run at maximum
speed for 5 seconds after the fan door is closed, then adjust to the appropriate level based on power
consumption.
† Only available when the MFC-8320-S is installed in an DFR-832x series frame.