Scotsman CME306 - Manual (Page 2)

Specifications
This ice machine is designed to be installed
indoors, in a controlled environment. It will operate
satisfactorily under a wide variety of conditions. Do
NOT operate the machine in temperatures it has
not been designed for. Do NOT operate the
machine above or below the voltage limits for the
particular model. Do NOT operate the machine
with too little or too much water pressure.
Operational Limits
Minimum Maximum
Air Temperature 50
o
F. 100
o
F.
Water Temperature 40
o
F. 100
o
F.
Water Pressure 20 psi 80 psi
Voltage (115 volt models) 104 126
Voltage (208-230 v models) 198 253
Voltage (50 Hz models) 207 253
Inlet water flow required is 1.25 GPM.
All models will fit a standard, 22" wide Scotsman
Ice Storage Bin such as the BH360.
Note: Slope front bins may need an internal baffle.
Scotsman’s BH360 has the required baffle. Baffle
must be approximately in the position shown in the
diagram on page 5.
Note: The ice machine will hang over the back of
the Lancer dispensers shown in the following list.
In addition, there may be other bins that can be
used, check Scotsman’s sales literature for
application information.
Note: This unit may not be stacked.
Bin and Dispenser Applications & Kits:
•
BH360 bin: Direct Fit
•
HD22 dispenser: Direct Fit.
•
ID150, add adapter kit KBT42
•
ID200 or 250, add adapter kit KBT43
•
Lancer 22” wide model: Add kit A37693-021.
•
Lancer 30” wide model: Add kit KLD22-30.
•
HTB555 - Add bin top kit KBT27
•
Bin’s with short/no baffle require thermostat
kit: KSTAT-22.
Scotsman reserves the right to make design
changes and/or improvements at any time.
Specifications and designs are subject to change
without notice.
Scotsman assumes no liability or responsibility of
any kind for products manufactured by Scotsman
that have been altered in any way, including the
use of any parts and/or other components not
specifically approved by Scotsman.
CME306 & CME456
May 2004
Page 2
Model Number Series
Dimensions
W" x D" x H"
(w/o bin)
Basic
Electrical
Condenser
Type
Minimum
Circuit
Ampacity
Max
Fuse*
Size
Refrigerant
Charge
(R-404A)
CME306AS-1 A, B or C 22 x 24 x 28 115/60/1 Air Cooled 16 20 23 ounces
CME306AS-32 A, B or C same 208-230/60/1 Air Cooled 7.9 15 23 ounces
CME306AS-6 A, B or C same 230/50/1 Air Cooled 15 15 23 ounces
CME306WS-1 A same 115/60/1 Water Cooled 16 20 15 ounces
CME306WS-32 B or C same 208-230/60/1 Water Cooled 7.4 15 13 ounces
CME306WS-6 A same 230/50/1 Water Cooled 15 15 15 ounces
CME306WS-1 B or C same 115-60/1 Water Cooled 16 20 13 ounces
CME306WS-1 B or C same 230/50/1 Water Cooled 15 15 13 ounces
CME456AS-1 A, B or C same 115/60/1 Air Cooled 19 20 24 ounces
CME456AS-32 A, B or C same 208-230/60/1 Air Cooled 9.8 15 24 ounces
CME456WS-1 A same 115/60/1 Water Cooled 19 20 17 ounces
CME456WS-1 B or C same 115/60/1 Water Cooled 19 20 14 ounces
CME456WS-32 B or C same 208-230/60/1 Water Cooled 9.2 15 14 ounces
CME456AS-6 A, B or C same 230/50/1 Air Cooled 7.9 15 24 ounces
CME456WS-6 A same 230/50/1 Water Cooled 7.1 15 17 ounces
CME456WS-6 B or C same 230/50/1 Water Cooled 7.1 15 14 ounces
* Or HACR circuit breakers.
Basic Information