Scotsman CME306 - Manual (Page 11)

CME306 & CME456
January 2000
Page 11
Bin Thermostat: Optional Installation
The normal bin control is the ice sensor set. An
option, required in some cases, is a thermostat. Its
bulb must be deployed after the ice machine has
been placed on the bin or dispenser.
Note: Some configurations may have parts that
vary from these instructions. Follow the
instructions for the particular configuration.
Before starting, remove the left side panel and any
baffle in the bin.
1. Place thermostat in machine behind the high
voltage box and secure to the existing holes with
two screws. Locate bin thermostat bulb.
2. Route bulb thru routing hole (located behind the
compressor).
3. Locate bin thermostat bracket.
4. Carefully position the thermostat bulb on the
bracket.
5. Fasten the bracket to the bottom of the ice
machine with the two 3-pronged knobs supplied
with the kit.
6. Pull excess capillary tubing into the machine..
7. Continue with the installation. If a baffle was
removed return it to its original position.
Note: If the machine is located at an altitude
higher than 2,000 ft., adjust the thermostat by
removing the plastic cover and rotating the
adjustment screw per the table.
Bin Thermostat Altitude Correction Table
CW Turns of Range Screw (under plastic cover)
Feet Turns Feet Turns
2000 55
o
8000 340
o
4000 160
o
9000 385
o
Use This Table to Adjust Thermostat
Routing Hole
Bin
Thermostat
Bracket
Insert Tip
Thermostat
Body