Rena T-650 - Manual (Page 84)

OPERATION
Job Example E: Applying Stamps
Feed Direction Feed Direction Feed Direction
IMPORTANT NOTES regarding the application of stamps:
ƒ The T-650 does not provide an “automatic positioning” feature for applying stamps, so
the stamp position (offset) must be done through the “Manual Setup” features to assure
proper stamp placement.
ƒ Due to the orientation of the stamps on the roll, the stamp or stamps must be placed at the
trailing edge of the media.
ƒ Head 2 can not be used to apply stamps.
ƒ In order to avoid wasting stamps; it is strongly suggested to use test stamps or tabs when
initially setting up the tabber for applying stamps. After you are comfortable with the
process, then you can switch over to using live stamps. Don’t forget to reprogram the
tabber (gap color, pitch, V-Tab, etc…) for the differences in these stocks.
IMPORTANT
BEFORE ATTEMPTING TO PROGRAM ANY JOB, SET UP THE FEEDER
AND THE TABBER TO FEED THE MEDIA. THEN PROGRAM THE JOB.
This exercise will walk you through the process of programming Head 1 to apply stamps.
1. Verify that Head 1 has been mechanically setup to “apply stamps”. See Section “ Head 1
Adjustment – Applying Stamps ”.
2. Open the Exit Roller Assembly.
3. Verify that the Peel Plate on Head 1 is set to the Side Tabbing Application position.
4. To begin programming; select Job #
from the Run screen.
T-650 Operations REV. 8/25/2010 84