Rena T-650 - Manual (Page 14)

GETTING ACQUAINTED
1. Remove the upper mounting screw and loosen the lower mounting screw from the Reel
Assembly Mounting Plates on Head 1 and Head 2.
2. Slide the appropriate Reel Assembly over the Mounting Plate, of Head 1 and Head 2,
until they bottom out on the lower mounting screw; as shown above.
3. Install the upper mounting screws and tighten.
4. Tighten the lower mounting screws.
Positioning the optional EasyFeed 120 Feeder
The optional EasyFeed 120 feeder should be placed onto the appropriate riser stand
(Part #: RS-500), and positioned at the entrance end of the tabber, as shown below.
T-650 Operations REV. 8/25/2010 14