Rena T-650 - Manual (Page 41)

OPERATION
If the # Tabs soft key is pressed.
The display will prompt you to select the
number of tabs/stamps you would like applied to
the mail piece, with the selected hea
Select option to edit, or
Press RUN to tab using Job 1.
Status: Head #n Manual Setup
# Tabs Position Pitch BACK
d.
ƒ 1 – Selects one tab/stamp
ƒ 2 – Selects two tabs/stamps
ƒ 3 – Selects three tabs/stamps
Press 1, 2 or 3 for the number of tabs.
Current Value: 2
Status: Head #n Manual Setup
1 2 3 BACK
ƒ
BACK – Brings you back to the previous
screen.
What displays next depends on the Head number
you are programming and how many tabs have
been selected:
Head #2:
If you select 1, 2, or 3 for # Tabs, the Select
Option to Edit screen will reappear.
Select option to edit, or
Press RUN to tab using Job 1.
Status: Head #2 Manual Setup
# Tabs Position Pitch BACK
Head #1:
If you select 1 for # Tabs, the Select Option
to Edit screen will reappear.
If you select 2 or 3, for # Tabs, you will be prompted to choose tab placement type.
ƒ Separate – Allows individual
adjustment of each tab/stamp position
via the Offset value.
ƒ Together – Tabs/Stamps are placed
next to each other, starting at the
Offset value you set for Tab 1.
ƒ
BACK – Brings you back to the previous screen.
Choose tab placement type
Status: Head #1 Manual Setup
Separate Together BACK
If the Position soft key is pressed.
The display will prompt you to set the Offset
value for each tab/stamp, starting with Tab1.
Select tab offset to edit
Tab 1 Tab 2 Tab 3 BACK
Select option to edit, or
Press RUN to tab using Job 1.
Status: Head #1 Manual Setup
# Tabs Position Pitch BACK
Offset Value = distance from leading edge of
mail piece to leading edge of tab/stamp.
ƒ Tab 1 – Use this soft key to set the offset value
for tab/stamp 1.
ƒ Tab 2 – Use this soft key to set the offset value
for tab/stamp 3.
ƒ Tab 3 – Use this soft key to set the offset value
for tab/stamp 3.
ƒ
BACK – Brings you back to the previous
screen.
T-650 Operations REV. 8/25/2010 41