Rena T-650 - Manual (Page 20)

MECHANICAL SETUP
Adjusting the Peel Plate Position for the Application
The Peel Plate on Head 1 has two positions; one for “side tabbing” and the other for “front
tabbing” (lead edge tab, front tab). The “side tabbing” position is also used to apply stamps.
IMPORTANT! The position of the Peel Plate is critical. Always check this when you
change Head 1 from Side Tabbing to Front Tabbing.
Use the image below to determine the correct peel plate position for your tabber.
SIDE
FRONT
The Peel Plate position is adjusted by loosening the locking knob and sliding the peel plate
up for front tabbing and down for side tabbing or stamping; then secure the locking knob.
See the images below.
Peel Plate Position Reference
Loosen
Knob
and Slide
Loosen
Knob
and Slide
FRONT TABBING
SIDE TABBING AND STAMPING
Proceed to the section titled “Loading Tab/Stamps
T-650 Operations REV. 8/25/2010 20