Quintum Technologies Tenor DX - Manual (Page 72)

7-4 P/N 480-0049-00-10
Chapter 7: Call Detail Recording
Establish connection between Tenor DX and CDR Server
In order to capture CDRs, a connection between the Tenor DX unit and the CDR server must be established. A
Tenor DX can be configured to connect up to two CDR servers via port 9002, 9003, 9004, and 9005. Based on
configuration, the Tenor DX unit can either establish a TCP/IP session with one or all of these CDR servers. A
flow diagram (Figure 7-1) illustrates the general transfer of information.
Figure 7-1 Flow of CDR Information
Before attempting to collect CDRs, you should configure the desired information. You can assign a CDR
server IP address, CDR server port number, CDR server password, and CDR format information using the fol-
lowing CLI commands: cdrserverip, cdserverport, cdrpassword, and cdrformat.
• CDRServerIPAddr: IP address of the CDR server. (Used when the Tenor DX unit established connec-
tion with the CDR server.)
• CDRServerPort: The application port numbers used by the CDRServer(s). (Used when the Tenor DX
establishes connection with CDR server.)
• CDRPassWord: Password to be used by the CDR server(s).
• CDRFormat: This configuration parameter command is used to choose which of the possible Call Data
Record output formats you would like to send to your CDR Server: Standard, Standard with session ID
functionality, Extended, Extended with session ID functionality, or Extended with Incoming Slot/Device
information. Possible entries are 0 (standard format), 1 (extended format), 3 (extended format), 4
(extended format), 100 (same as selection 0 with session ID functionality), 101 (same as selection 1 with
session ID functionality), 103 (same as selection 3 with session ID functionality), 104 (same as selection
4 with session ID functionality).
Tenor CMS CDR Server
Tenor CMS connects
to CDR Server automatically.
(after initial configuration of
S erver IP Address & Port Number)
or
CDR Server logs into Tenor CMS'
Port Number 9002 or 9003
TCP/IP Connection Established
Sends Welcome Message
Sends Password Prompt
Enters Password
Verifies Password
Provides CMS' IP address &
U nit N ame
Provides last CDR Sequence
Number received
Begins delivering CDR's
DX
Tenor DX’s IP Address &
DX