Quintum Technologies Tenor DX - Manual (Page 44)

P/N 480-0049-00-10 3-9
Chapter 3: Installation
Connect to PC Console
You will need to connect the Tenor DX to your workstation’s serial port via RS-232 connection. (This connec-
tion will be used when you assign an IP address to the unit.) For the instructions below, it is assumed you are
connecting to a Windows PC.
Figure 3-7 Connect to PC Com Port
1. Insert the male end of the DB-9 cable into the port labeled Console. (See Chapter 2: Hardware Compo-
nents for RS-232 connector pinouts.)
2. Insert the female end of the DB-9 cable into your workstation’s serial port (see your PC documentation for
more information about this port).
1 2 3 4 5 6 7 8
R
E
S
E
T D I A
G
CONSOLE POWER
ALERT
LAN 1 LAN 2
Line/Act
100
Line/Act
100
DB-9