Quintum Technologies Tenor DX - Manual (Page 66)

P/N 480-0049-00-10 6-7
Chapter 6: Working with SNMP
Working with SNMP
View traps
You can view the traps HP Openview received from the Tenor DX unit as follows:
NOTE: Ensure HP Openview is running.
1. From the HP Openview map where the Tenor DX units appear, right-click on the Tenor DX icon for which
you want to view traps and select Alarms.
2. From the Alarm Categories window, click on All Alarms. All traps (alarm messages) will be listed in the
order in which they occurred.
View Alarm Status via Tenor DX icon
Through the color of a Tenor DX icon on the HP Openview desktop, you can determine the alarm state of the
unit as well as view the corresponding alarms. Valid icon colors are listed below.
• Green Icon. No Alarm indicated.
• Red Icon. Critical Alarm (used for when HP Openview cannot communicate with the Tenor DX or there
is a severity level 1 alarm).
• Orange Icon. Major Alarm (used for severity level 2 alarms).
• Yellow Icon. Minor Alarm (used for severity level 3 alarms).
• White Icon. Info Alarm (used for severity level 4 alarms).
View the alarms associated with a Tenor DX unit as follows:
NOTE: Ensure HP Openview is running.
1. From the HP Openview desktop, identify the icon for the Tenor DX unit from which you would like to
view alarms.
2. According to the color of that icon, determine the alarm state from the list above.
3. To view the alarms associated with that icon, right-click from anywhere on the HP Openview desktop and
select Alarms. The All Alarms Browser window will appear, which contains the list of alarms.