What’s included, What’s included? -2 – Quintum Technologies Tenor DX User Manual
Page 7
Preface-2
P/N 480-0049-00-10
About this Guide
What’s included?
This product guide is divided into chapters; each chapter describes a specific topic. The following chapters are
included:
•
About this Guide: Describes what is included in the Product Guide, including typographical conventions.
•
Chapter 1: Overview. Includes a general overview of the product, including a description of the Tenor
DX’s features and capabilities.
•
Chapter 2: Hardware Components. Hardware description, including the front and rear panels, as well as
LEDs and required cables.
•
Chapter 3: Installation. Describes how to install the Tenor DX unit, including how to connect, power up
and assign the IP address.
•
Chapter 4: Getting Started: Tenor Configuration Manager/Tenor Monitor. This chapter tells you how to
use the Tenor Configuration Manager and Tenor Monitor to configure/monitor the unit.
•
Chapter 5: Getting Started: Command Line Interface (CLI). This chapter tells you how to access the CLI
and execute commands. A description of each CLI mode is also included.
•
Chapter 6: Working with SNMP. This chapter describes the SNMP protocol and how to use it with the
Tenor DX.
•
Chapter 7: Call Detail Recording. Describes the Call Detail Recording (CDR) feature, including how to
set up the CDR server and assign a password. In addition, instructions for reading CDR output are also
included.
•
Chapter 8: System Alarms. Describes how to monitor and view alarms via Command Line Interface
(CLI). In addition, alarm definitions are also included.
•
Chapter 9: Diagnostics/Maintenance. Describes how to troubleshoot and monitor the health of the sys-
tem.
•
Chapter 10: Using IVR. Describes the Interactive Voice Response (IVR) system for support of pre-paid
and post-paid calls.
•
Appendix A: Specifications/Approvals: A list of Tenor DX specifications and approvals.
•
Glossary
•
Index
•
Warranty