Montigo 30FID Traditional - Manual (Page 49)

Page 49
XG00516- 150204
I-Series Indoor Gas Fireplace
Operation
Fan Speed Control
The fireplace is equipped with optional hot air circulating fans.
The speed of the fans can be controlled by the Proflame
system. The fan speed can be adjusted through six (6) speeds.
To activate this function use the Mode Key, see Figure 8
Sec.10, to index to the fan control icon, see Figure 20 Sec.10.
Use the Up/Down Arrow Keys, see Figure 8 Sec.10, to turn
on, off, or adjust the fan speed, see Figure 20 Sec.10. A single
"beep" will confirm reception of the command.
Figure 18 Sec.10
Accent Light Control
The fireplace is equipped with variable accent lights. The
accent light function controls the Accent Lights. To activate this
function use the Mode Key, see Figure 8 Sec.10, to index to
the accent light icon, see Figure 21 Sec.10.
Pressing the Up Arrow Key will turn the light on at the lowest
setting. Continue pressing up to get brighter. Pressing the
Down Arrow Key will turn the lights down until you get to the
off position. A single beep will confirm the reception of the
command.
Figure 19 Sec.10 Light Control
Disabling Thermostat
Some jurisdictions and bedroom installations require the
thermostat to be disabled.
1. Partially take out one battery, see Figure 18 Sec.10.
2. Insert the battery while holding down the thermostat button.
The remote screen will display 'Clr' while the button is held ..
down. See Figure 19 Sec.10.
3. To enable thermostat repeat steps 1-2. The remote screen .
will display 'set' while the thermostat button is held down.
Figure 20 Sec.10 Fan Speed Control
Figure 21 Sec.10 Light Control