beautypg.com

Montigo 1001 TH-A User Manual

1001 th-a, Installation and operating instructions, Introduction

background image

Rev. 8/22/05 Page 1 of 9




1001 TH-A

INSTALLATION AND OPERATING INSTRUCTIONS



INTRODUCTION

SKYTECH’S remote control system was developed to provide a safe, reliable and user-friendly remote control system for gas heating
appliances. This all battery system operates independently of household current. The system operates on radio frequencies with a
non-directional signals. The SYSTEM’s operating range is approximately 20 feet range. The system operates on one of 1,048,576
security codes that are programmed into the transmitter at the factory; the remote receiver's code must be matched to that of the
transmitter prior to initial use.




TRANSMITTER

This remote control SYSTEM offers the user a battery-operated remote control
that operates most millivolt gas valves used in some heater rated gas logs, gas
fireplaces and other gas heating appliances.


The transmitter operates on (2) 1.5V AAA batteries.


It is recommended that ALKALINE batteries always be used for longer battery life
and maximum operational performance.


Before using the transmitter, install the (2) AAA transmitter batteries into the
battery compartment. (Use caution that batteries are installed in the proper
direction)


KEY SETINGS


ON - Operates unit to on position, Manually ON.

OFF - Operates unit to off position, Manually OFF.

MODE - Changes unit from manual mode to thermo mode.

SET - Sets temperature in thermo mode.






1. DISPLAY

Indicates CURRENT room temperature .

2.

0

F OR

0

C

Indicates degrees Fahrenheit or Celsius.

3. FLAME

Indicates burner/valve in operation.

4. ROOM

Indicates remote is in THERMO operation.

5. TEMP

Appears during manual operation.

6. SET

Appears during time the of setting the desired
temperature in the thermo operation..

ROOM

LCD - Liquid Crystal Display

TEMP

1

2

3

SET

4

5

6

ON

MODE

OFF

SET

1

2

3

4

IF YOU CANNOT READ OR UNDERSTAND THESE INSTALLATION INSTRUCTIONS DO NOT

ATTEMPT TO INSTALL OR OPERATE

ON

MODE

OFF

BUTTON

WALL CLIP

SLOT

BATTERY

COMPARTMENT

FRONT

BACK

OFF

SET

ON

BUTTON

MODE

BUTTON

SET

BUTTON

Review COMMUNICATION SAFETY SECTION under TRANSMITTER section and THERMO SAFETY SECTION under REMOTE
RECEIVER section. These signal/temperature safety features shut down the fireplace system when a potentially unsafe condition exists.