Montigo 1001-A - Manual

REV 8/22/05 Page 1 of 6
1001-A
INSTALLATION AND OPERATING INSTRUCTIONS
INTRODUCTION
This SKYTECH remote control system was developed to provide safe, reliable, and user-friendly remote control system for gas heating
appliances. The system can be operated manually from the transmitter. The system operates on one of 65,536 security codes that are
programmed into the transmitter at the factory.
TRANSMITTER
The transmitter operates on a 12V battery (included) made specifically for remote
controls and electronic lighters. Install the 12V battery supplied with the unit into
the battery compartment.
It is recommended that AKALINE batteries always be used for longer battery life
and maximum operational performance.
The transmitter has ON and OFF functions that are activated by pressing either
button on the face of the transmitter. When a button on the transmitter is
pressed, a signal light on the transmitter illuminates briefly to verify that a signal
has been sent. Upon initial use, there may be a delay of three seconds before
the remote receiver will respond to the transmitter. This is part of the system’s
design. If the signal light does not illuminate, check the position of the
transmitter’s battery.
RECEIVER
The remote receiver operates on 4 AA-size 1.5V batteries. It is recommended that ALKALINE batteries be used for longer battery life
and maximum microprocessor performance. IMPORTANT: New or fully charged batteries are essential for proper operation of the
remote receiver.
The remote receiver houses the microprocessor that responds to commands from the transmitter to control system operation. The
remote receiver has a 3-position slide switch for selecting the MODE of operation: ON/REMOTE/OFF
• With the slide switch in the ON position (toward the LEARN button), the system will
remain on until the slide switch is placed in the OFF or REMOTE position.
• With the slide switch in the REMOTE position (centered), the system will only operate
if the remote receiver receives commands from the transmitter.
• With the slide switch in the OFF position (away from the LEARN button), the system
is off.
• It is suggested that the slide switch be placed in the off position if you will be
away from your home for an extended period of time. If the remote receiver is
mounted out of children’s reach, placing the slide switch in the OFF position
also functions as a safety “lock-out” by both turning the system off and
rendering the remote receiver inoperative.
REMOTE
ON
OFF
LEARN
ADJ.
Requires 4-AA 1.5V
alkaline batteries
Learning
button
Frequency
adjusting
access hole Remote Receiver
Battery cover slides on/off
Slide
Switch
ON
REMOTE
OFF
IF YOU CANNOT READ OR UNDERSTAND THESE INSTALLATION INSTRUCTIONS DO NOT
ATTEMPT TO INSTALL OR OPERATE
ON
OFF
12V
BATTERY
COMPARTMENT
FRONT BACK
SIGNAL
LIGHT
ON/OFF
BUTTONS