Montigo H34 - Manual

XG0903 - 150204
Brackets to be
flush with top of
fireplace frame,
(Typical)
Align (2) attachment brackets
on center of frame verticals
(Left and Right side Typical)
Moving Brackets (2)
(Left and Right side Typical)
Mounting Holes (3) per side.
(Left and Right side Typical)
Bracket to be
Flush with
outside edge
of fireplace,
(Typical)
Installing the H34/H38/H42 Surround
for use with:
H-Series; H34-DF
H-Series; H38-DF
H-Series; H42-DF
®
C US
Tools Required
1) Power Drill, (eight 1/8" holes)
2) #8 Hexhead Driver, (to match hardware)
3) Carpenters level (Final Step, if required)
Installing the Surround
To install the Montigo Stainless steel or Black contemporary
surround to the H34DF, H38DF, or H42DF follow these steps.
Step 1. Mark the location of the holes needed.
From the package of hardware locate one of the Attachment
Brackets. Hold this part in place as shown in Figure 2. With a pen-
cil or pen mark the (6) six holes on the face of the fireplace frame,
(see Figure 2.) Note: Ensure the brackets align with Figure 2. Below.
Figure 2. Bracket Alignment
Step 2. Drill holes.
Before you go any farther now is the time to double check the loca-
tion of the holes, do they agree with Figure 2. If you are satisfied
with the location of the holes, use a punch to mark the holes, then
using a 1/8" drill, drill out the six holes.
M
N
P
1”
O
Surround Dimensions
M N O P
H34DF 31 7/16" 24 1/4" 45 15/16" 38 7/8"
H38DF 35 3/16" 26 3/8" 49 11/16" 41"
H42DF 39 5/8" 30 7/16" 54 1/8" 45 1/16"
Parts Included
1) 1-Pc, Surround
2) 2-Pcs, Attachment Brackets
3) 4-Pcs, Moving Brackets
4) 1-Pkg. Hardware
Figure 1. Surround Dimensions (tolerance within 1/16")
A
REVISIONS
REV. DESCRIPTION DATE CHANGED BY
- . - -
1:2
DWG. NO.
SHEET 1 OF 1 WEIGHT:
P38-MAN3
Finish
MATERIAL
DIMENSIONS ARE IN INCHES
TOLERANCES:
FRACTIONAL 1/32"
TWO PLACE DECIMAL .015"
THREE PLACE DECIMAL .005"
ALL BENDS ARE ASSUMED
TO BE 90 UNLESS NOTED
OTHERWISE.
Revision / Date
Drawn by
DATE NAME
P38
THE INFORMATION CONTAINED IN THIS DRAWING IS THE SOLE PROPERTY OF CANADIAN HEATING PRODUCTS. ANY REPRODUCTION IN PART OR AS A WHOLE WITHOUT THE WRITTEN PERMISSION OF CANADIAN HEATING PRODUCTS IS PROHIBITED. PROPRIETARY AND CONFIDENTIAL Y:\CADD\38\P38\P38
April-01-15 8:18:44 AM
SCALE
PC
Description FACEPLATE BRACKET
MANUAL
A
Revision
04/01/2015
1
3
2
4