beautypg.com

Montigo IOSK5 User Manual

Installation instruction kit part no. iosk5

background image

Follow the instructions for the unit installation in the up to Step 1 on

Page 7 of the installation guide.

The unit is in place with the screws removed as illustrated there.

STEP 1: Back frame the unit with the metal header supplied by Montigo

above the unit and either combustible or non-combustible framing to the

sides and bottom maintaining clearances as shown and ensuring the

gallvanized apron (Fig 1, Part No. 520-551) can be attached to the framing.

Figure 1: Indoor/ Outdoor Sealing Kit Ccmponents

Figure 2: Backframe unit

CLEARANCE TO COMBUSTIBLES:

6" Top, 3" each side, 3" bottom from the protruding window box.

Figure 3: Attach galvanized apron to unit

STEP 4: Attach the stainless steel frame (Fig. 1, Part No. IOSK5-A01)

to the galvanized frame lining up the holes around perimeter. Secure in

place through holes across the top and down the sides. Do not secure

the bottom flange.

STEP 5: Apply approved waterproofing membrane over the flange of

the frame on the top and sides and under the flange of the frame at

the bottom. The membrane should overlap the frame approximately 2"

around the perimeter.

STEP 6: All facing materials may now be installed over the frame.

BE CERTAIN TO MAINTAIN 6" ABOVE AND 3" ON SIDES AND BOTTOM

TO ANY COMBUSTIBLE MATERIAL

STEP 2: Place the galvanized apron and attach to the unit using the 6

screws removed from the unit face, Figure 3.

STEP 7: Mount the framed glass (Fig 1, IOSK5-A02) onto the unit and

secure in place first with only the two side screws.

STEP 8: Place the Galvanized strips (4 supplied) at each corner lining up

screw holes and secure both the strips and the framed glass to the unit.

STEP 9: Attach the stainless steel trim (Fig1, IOSK5-A03), by placing it

on and ensuring the magnets catch the previously placed galvanized strip.

Figure 4: Install silicone gasket

STEP 3: Install the silicon gasket material (supplied by Montigo) in one

continuous strip with the joint at the bottom, Figure 4.

Indoor / Outdoor Sealing Kit For R520 ST

Use this instruction in conjuction with unit

instruction manual (Doc. XG0773)

Installation Instruction

Kit Part No. IOSK5

IOSK5-A03

IOSK5-A02

IOSK5-A01

520-551