Montigo RX200 - Manual

Upgrade Kit
Proflame 2 Upgrade Kit RX 200 NG/LP
Page 1 XT0016 - 092214

The installation of this kit must be done by a qualified and
certified gas appliance installer.

Check local codes and read all instructions prior to installation.
Ensure that all power to the appliance is off at the electrical breaker or fuse
before beginning installation. Ensure gas is turned off at the shutoff valve before
beginning installation.
CAUTION
This kit is for use with the following models:
B34DT-2-F : B34 Top Vent, Electronic Ignition, IPI
B34DR-2-F : B34 Rear Vent, Electronic Ignition, IPI
B38DT-2-F : B38 Top Vent, Electronic Ignition, IPI
B38DR-2-F : B38 Rear Vent, Electronic Ignition, IPI
®
C US
Warning: If the information in these instructions is not followed
exactly, a fire or explosion may result causing property damage,
personal injury or loss of life.

Do not store or use gasoline or other flammable vapors and liquids in the
vicinity of this or any other appliance.

What To Do If You Smell Gas:
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbor's phone. Follow the gas
supplier's instructions.
• If you cannot reach your gas supplier, call the fire department.
 Installation and service must be performed by a qualified installer, service agency or
the gas supplier.
Upgrade Kit NG/LP Proflame 2 (Basic to Full
Load with Remote)