Step a.1 – Measurement Computing DaqBook 2000 Series Installation User Manual

Page 5

Section A

969696

Connecting a

DaqBook/2000A or /2000X to a PC Parallel Port A-1

Section A

Connecting a DaqBook/2000A or a DaqBook/2000X to a PC Parallel Port

CAUTION

Turn off power to the system devices and externally connected equipment before connecting cables.
Electric shock or damage to equipment can result even under low-voltage conditions.

Take ESD precautions (packaging, proper handling, grounded wrist strap, etc.)

Reference Note: Adobe PDF versions of user manuals will
automatically install onto your hard drive as a part of product
support. The default location is in the Programs group, which
can be accessed from the Windows Desktop. You can also
access documents directly from the data acquisition CD via the
button located on the CD’s opening screen.

Refer to the PDF documentation for details regarding both
hardware and software. Note that hardcopy versions of the
manuals can be ordered from the factory.

Minimum System Requirements

PC system with Pentium

Processor

Windows Operating System
RAM, as follows:

32 Mbytes of RAM for Windows 95/98/NT
64 Mbytes of RAM for Windows Me
64 Mbytes of RAM for Windows 2000
64 Mbytes of RAM for Windows XP

STEP A.1 –

Install the Software

Remove

previous version Daq drivers, if present. You can do this through the Windows Add/Remove

Programs feature.

2. Place the Data Acquisition CD into the CD-ROM drive. Wait for PC to auto-run the CD. This may take a

few moments, depending on your PC. If the CD does not auto-run, use the Desktop’s Start/Run/Browse
feature to locate and run the CD’s setup.exe file.

3. After the intro-screen appears, follow the screen prompts.