Measurement Computing DaqBook 2000 Series Installation User Manual
Page 19

Section B
969596
Connecting a DaqBook/2000E or WaveBook/516E to the Ethernet B-11
4. Test the system connections.
a. Make sure the device has been properly installed and is powered-on.
b. Make sure all cables are properly and securely connected.
c. Click the “Test Hardware” tab.
d. Click the <Resource Test> button.
The test results have two components: Resource Tests and Performance Tests.
Appendix G, Resource and Performance Tests
, includes a brief explanation of the tests.
When testing a WaveBook or DaqBook device, if the unit does not respond within 30
seconds perform the following steps:
1) reboot the system
2) upon power-up, re-open the Daq* Configuration applet
3) select another configuration setting
4) reinitiate the test
This completes the procedure for connecting a DaqBook/2000E or WaveBook/516E to the Ethernet. At this
point you should refer to the more detailed user documentation that applies to your Ethernet-connected
device. User’s manuals typically include pinouts, information on system explanation, data acquisition, and
links to software and programming documents (in PDF format).
Reference Notes:
For additional device and system information:
➣
DaqBook/2000E users should refer to the DaqBook/2000 Series User’s Manual
(p/n 1103-0901) and the DBK Options Manual (p/n 457-0905).
➣
WaveBook/516E users should refer to both the WaveBook User’s Manual,
(p/n 489-0901) and the WBK Options Manual (p/n 489-0902).
➣
Programming information is contained in the Programmer’s Manual, (p/n 1008-0901).
Note: You can access PDF documents directly from the opening screen of the data acquisition CD
via the <View PDFs> button.