Measurement Computing DaqBook 2000 Series Installation - Manual (Page 4)

IG-4 DaqBook/2000 Series Installation Guide 968596 1103-0940, rev 2.0
A Comparison of Device Features
DaqBook/2000A DaqBook/2000X DaqBook/2000E
Feature Description Applies to:
16
Analog Input Channels
Analog Input signals enter through P1 and/or P4, go to MUX, to PGA, to Gain
& Offset Amplifier, then to Analog-to-Digital Converter (ADC).
All Models
4
(with DBK46)
Analog Output Channels [Available only with DBK46 Option]
Digital Signals go through Digital-to-Analog Converters via the optional
DBK46 plug-in card, then through “DAC Out” on P3 and P4. The card
includes a 256K Sample Buffer. Note that the DBK46 option is a “Factory
Install” Option Only.
Each model,
providing a
DBK46 is
installed.
40
Digital I/O Channels
Digital signals pass through one 16-bit Digital I/O Port and three 8-bit Digital
I/O Ports located on P2, P3, and/or P4.
All Models
6
Counter/Timers
Four 16-bit Counter Input signals and Two 16-bit Timer Output signals via P3
and/or P4 and System Controller.
All Models
10/100BaseT Ethernet Interface located on the chassis
The DaqBook/2000E includes a 10/100BaseT Ethernet interface.
Note that DaqBook/2000A and DaqBook/2000X can connect to the
DaqBook/2000E, or to a WBK25 Ethernet module.
/2000E
3 Card Exp.
3 Card Expansion
The DaqBook/2000X includes three expansion slots that can accept a
wide variety of analog and digital DBK signal conditioning cards.
/2000X
DaqBook/2000 Series Devices are high-speed, multi-function, data acquisition systems for use with
notebook and desktop PCs. They feature a 16-bit, 200-kHz A/D converter, digital calibration, 40 digital
I/O lines, four counters, and two timers and, if the optional DBK46 card is installed, four 16-bit, 100-kHz
D/A converters
Up to 470 channels of analog and digital I/O can be accessed with one DaqBook/2000 Series Device.
All input and output signals can be connected via the three 37-pin DSUB connectors [P1, P2, and P3]
located on the front panel. Duplicate I/O connectivity is also available on the rear panel via the 100-pin, P4
connector.
• P1 – Analog input port for 16 single-ended or 8 differential analog inputs with 13 software
programmable ranges ( ±10 V to ±156 mV full scale).
• P2 – General purpose digital I/O port with 24 lines, or digital I/O expansion port controlling
up to 192 external lines.
• P3 – 16-bit digital I/O port, counter inputs, timer outputs, and analog outputs.
• P4 – this 100-pin connector allows for optional connection to a DBK200 Series Device for
expansion from the rear panel. P4 connectivity provides no additional I/O to that which is
available to P1, P2, and P3.