Measurement Computing DaqBook 2000 Series - Manual (Page 52)

STEP 6 – Configure Device Network Settings using DaqIPConfig
Applies only to a LAN (Local Area Network), which has a no DHCP server.
If using a LAN (Local Area Network), which has a DHCP server, skip this section and continue
with STEP 7 - Configure and Test the System using the Daq*Configuration Applet (page 6-11).
The DaqIPConfig applet, designed for 32-bit Windows NT/2000/XP systems. DaqIPConfig allows you to change
the IP address of a device to match the address of a host computer. The applet is located in the program group for
the associated device and can be accessed from the Windows Desktop via the start menu.
1. Locate the DaqIPConfig Applet.
Locate the DaqIPConfig applet by navigating from the Windows’ Desktop as follows:
Start Menu ⇒ Programs ⇒ IOtech DaqX Software ⇒ DaqIPConfig
2. Open the DaqIPConfig Applet.
Click on the DaqIPConfig selection to open the applet.
DaqIPConfig
3. Select the device that is to have the address change.
Note: In the above figure there is only one device to select, i.e., DaqBook/2020.
4. Set the internet protocol (TCP/IP) settings to be compatible with host computer.
(a) Select the radio button labeled “Use the following IP address.”
(b) Enter the new internet protocol settings. If needed, consult your network administrator for
acceptable numbers.
(c) Click the button.
5. Reboot the device.
The new IP address will not take affect until the device has been powered-off, then powered back on.
6. Repeat steps 3, 4, and 5 for other devices in the system.
After configuring the network settings for all devices, proceed to Step 7.
6-10 Configuring the System for Operation 898095 DaqBook/2000 and DaqOEM/2000 Series