Ch 6 - configuring the system for operation, Configuring the system for operation 6 – Measurement Computing DaqBook 2000 Series User Manual
Page 43
Configuring the System for Operation 6
Step 1 - Install the Software ….. 6-2
Step 2 - Determine the type of Network Connection …… 6-2
Step 3 - Connect System Components …… 6-5
Step 4 - Power-up the System …… 6-6
Step 5 - Configure the Computer’s Network Settings …… 6-7
Step 6 - Configure Device Network Settings using DaqIPConfig …… 6-10
Step 7 - Configure and Test the System using the Daq Configuration …… 6-11
Connecting a DaqBook/2000 Series Device to the Ethernet
The DaqBook/2000 and DaqOEM/2000 Series devices connect directly to an Ethernet port on a PC or
network hub via a built-in 10/100BaseT Ethernet interface. An Ethernet patch cable CA-242 (1.5 foot) or
CA-242-7 (7 foot) cable is used to make the connection.
Contact the factory or your service representative in regard to Ethernet connectivity if
your operating system is other than Windows NT, Windows 2000, or Windows XP.
DaqBook/2000 and DaqOEM/2000 Series
898095
Configuring the System for Operation 6-1