Legrand 68REC - Manual

1
Wiremold electrical systems conform to and should be properly
grounded in compliance with requirements of the current National
Electrical Code or codes administered by local authorities.
All electrical products may present a possible shock or fire
hazard if improperly installed or used. Wiremold electrical products
may bear the mark as UL Listed and/or Classified and should
be installed in conformance with current local and/or the National
Electrical Code.
Products Covered: 6ATCP, 6ATP, 6ATCPAV, 6ATPAV, 6ATC, 6AT, 6STC, 6CTC, 6CT, 68REC, 68MAAP, 682A, 68B, 6DP,
6DEC, 6S1, 6S2, 6MAAP, 6AAP, 6MAAP2A, 6B, 6TS, 6STCP, 6STCPAV, 575CHA, 5PTHA, 5BLH,
175CHA, 1125CHA, 1PTHA, 1BLH, CE6STCP, CE6STCPAV
CAUTION: DO NOT operate tile stripper, cleaning, or resurfacing equipment over top of covers. This may result in
damage to the surface finish of the product.
Suitable for use in air handling spaces in accordance with Sec. 300-22 (C) of the National Electrical Code.
Evolution ™ Series
6" Poke-Thru Devices
I N S T A L L A T I O N I N S T R U C T I O N S
Installation Instruction No.: 1 007 154 R2 – Updated May 2010
CAUTION: Be certain to locate hole at least 6" [152mm] from any wall or
pillar to leave enough room for Poke-Thru cover assembly.
IMPORTANT: Please read all instructions
before beginning.
CAUTION: Minimum spacing of 2ft on center and not more
than one device per each 65 square feet of floor
area in each span.
Step 2 Remove 6 1/2" dia. [166mm] section from
carpet or tile. Use template provided. Step 1 Layout and locate position of hole(s).
Step 3 Create core hole according to the
dimensions provided in the chart.
FLOOR PREPARATIONS
24" [610mm] Min
Center – Center
6 1/2"
[166mm]
Covered Floors 6" [152mm] 6 1/8" [156mm]
(Carpet, Tile or
Wood)
Bare Concrete 6 1/16" [154mm] 6 1/8" [156mm]
or Terrazzo
FLOOR CORE CORE
TYPE SIZE (Min.) SIZE (Max.)