Kawai MP6 - Manual (Page 44)

44
6. M
E
NU But
tons
6.2.37 Zone Transpose
This parameter sets the amount of transposition for the selected zone. The
available range is three octaves up or down (+/-36 semitones).
Note:
To set the master transpose, press the TRANSPOSE button and set the value.
6.2.38 Volume
This parameter sets the volume level for the selected zone. The value can be
changed by using the FADER or VALUE buttons.
For External zones, when the MIDI Transmit Control Change is “Off”, this page
won’t be displayed.
6.2.39 Pan
Int This sets the pan-pot (right and left balance).
Ext This sets the pan-pot value that will be transmitted to external sound
modules. If the MIDI Transmit Control Change is “On”, the value is
transmitted when a SETUP is recalled. When the MIDI Transmit Control
Change is “Off”, this page won’t be displayed.
* The value changes from L64 to R63.
* When the Tone Wheel sound is selected, this page will not be displayed.
6.2.40 Fine Tune
Int This is a fine tuning function for values smaller than a semi-tone.
Ext This is used to transmit fine tuning settings to external sound modules. If
the MIDI Transmit Control Change is “On”, the value is transmitted when
a SETUP is recalled. When the MIDI Transmit Control Change is “Off”, this
page won’t be displayed.
* The value changes from -63 to +63.
1 Concert Grand
S Zone Trans= 0
1 Concert Grand
S Zone Trans= 0
1 Concert Grand
S Volume = 127
1 Concert Grand
S Volume = 127
1 Concert Grand
Pan = R10
1 Concert Grand
Pan = R10
1 Concert Grand
S Fine Tune= 0
1 Concert Grand
S Fine Tune= 0