Kawai MP6 - Manual (Page 15)

15
2
. Basic Oper
a
tions
2. Basic Operations
2.1 Getting Ready
Since the MP6 has no built-in speakers, you will need to connect a mixer,
keyboard amplifier or headphones in order to listen.
Turn the MP6 on, using the POWER SWITCH on the rear panel.
It is recommended to turn the MP6 on before turning on any amplifiers in order
to avoid switching noise.
What you need to know before starting:
Please read this part for a better understanding of the MP6 structure.
The MP6’s SOUND and SETUP modes are largely the same. The main difference
between the two is that SETUP is used to recall stored SETUPs. Edits and changes
can be made freely in either mode, using the 4 faders, 4 knobs and MENU
functions, however edits made in SOUND mode will be lost when the power is
turned OFF and must therefore be stored in SETUP mode.
In order to start from scratch, use the SOUND mode and press PIANO ONLY
first.
In order to modify a SETUP, select the desired SETUP, perform any edits, and
store the changes as a SETUP.
If selected sounds do not sound correct, it is possible that parameters (knobs
etc.) were edited. To restore sounds to their default setting, use the PIANO ONLY
function, then re-select the desired sound.