Hypertherm HT2000-200 Volt - Manual (Page 102)

HySpeed HT2000
Instruction Manual
6-7
OPERATION
19
Programmable Remote (PR) V/C Module (Fig. 6-4)
• VOLTAGE
LEDs
Displays cutting voltage during cut sequence.
• CURRENT
LEDs
Displays cutting current during cut sequence.
• UP / DOWN
LEDs
Indicates that torch height is being adjusted up or down.
Timer / Counter (Fig. 6-5)
• STARTS
LCD Counter (w/Reset)
Indicates the number of arc starts
• ARC TIME
LCD Counter
Indicates the cumulative time that the arc is on in hours.
• ERRORS
LCD Counter (w/Reset)
Indicates the number of times that the arc cut cycle ended before the programmed current ramp-down time
had elapsed.
This reading provides a direct correlation to the long-life operation of the electrode; the higher the reading,
the shorter the electrode life.
Figure 6-4 Programmable Remote (PR) V/C Front Panel Indicators
Figure 6-5 Timer / Counter
Reset Reset
UP LED
DOWN LED