Hypertherm HSD130 HySpeed Plasma - Manual (Page 102)

INSTALLATION
3-34 HySpeed HSD130 RHF Instruction Manual
Wire Input/ Input/
color Pin no. Output Signal name Function Output Notes
Black 1 Input None Not used Output
Red 20 Input None Not used Output
Black 2 Output None Not used Input
Green 21 Output None Not used Input
Black 3 None Not used
Blue 22 None Not used
Black 4 Output Motion E (-) Notifies the CNC that an arc transfer has occurred and to begin Input 2
Yellow 23 Output Motion C (+) machine motion once the CNC’s pierce delay has timed out. Input
Black 5 Output None Not used Input 2
Brown 24 Output None Not used Input
Black 6 Output Rampdown error E (-) Notifies the CNC that a rampdown error has occurred Input 2
Orange 25 Output Rampdown error C (+)
Red 7 Output None Not used Input 2
White 26 Output None Not used
Red 8 Output None Not used Input 2
Green 27 Output None Not used Input
Red 9 Output None Not used Input 2
Blue 28 Output None Not used Input
Red 10 Output None Not used Input 2
Yellow 29 Output None Not used Input
Red 11 None Not used
Brown 30 None Not used
Red 12 Input Corner - CNC Notifies the plasma system that a corner is approaching and to Output 1
Orange 31 Input Corner + reduce cut current (Cut current is CNC selectable or defaults to 75%. Output
of cut current)
Green 13 Input Pierce - CNC Notifies the plasma system to maintain the shield preflow until Output 1
White 32 Input Pierce + the CNC releases the signal.
Green 14 Input Hold - Not required without Command THC. Command THC requires signal Output 1
Blue 33 Input Hold + to preflow gases during IHS.
Green 15 Input Start - CNC initiates the plasma arc. Output 1
Yellow 34 Input Start + Output
Green 16 None Not used
Brown 35 None Not used
Green 17 None Not used
Orange 36 Power ground Ground
White 18 Power ground Ground
Black 37 CNC +24 VDC Available 24 VDC (200 milliamps maximum) See notes 3
19 CNC + 24 VDC Not connected
Power supply to CNC interface cable 8
Power supply CNC
Part no. Length
123022 7.5 m (25 ft)
123023 15 m (50 ft)