Harken 3813 System AA Battcar - Manual (Page 15)

System AA (CB) 15
Operation – CB System (Slug Mount/Drill & Tap) Load Sail on Cars
1. Beginning with lower cars, use 4 mm hex wrench and 8 mm wrench or
nut driver to attach sail to cars. Tighten locknut until bottom tip of fastener
is flush with nut.
4. Attach head of sail to headboard car with clevis pin and cotter pin.
2. Screw threaded stud to terminal.
3. Load toggle using 4 mm hex wrench and 8 mm wrench or nut driver.
Tighten locknut. Do not over tighten.