10 setting up the ethernet interface – Guralp Systems CMG-6TD User Manual

Page 32

Installing the 6TD

The illustration above shows serial data in blue, network data in yellow and
power connections in red.

The Lantronix module can be powered down with the CD24 command

ETHER DISABLE

and powered up with the command

ETHER ENABLE

Certain operations, such as a firmware upgrade, can result in power to the
Lantronix module being turned off. In these cases, the ETHER ENABLE

command should be used to restore power.

4.10 Setting up the Ethernet interface

CMG-6TD instruments with Ethernet features installed use an embedded
Lantronix Wi-Port-NR module to provide the network interface. This module

can be configured using a built-in Web server.

Before you can access the Web server, however, you will need to assign the

device an IP address. This can be done using Lantronix' DeviceInstaller
utility for Microsoft Windows, or using a DHCP server. You will need a PC

with a network interface installed.