Gasboy CFN Series Tokheim Pump PC Interface - Manual (Page 18)

© 2011 GASBOY
7300 West Friendly Avenue · Post Office Box 22087
Greensboro, North Carolina 27420
Phone 1-800-444-5529 ·
http://www.gasboy.com · Printed in the U.S.A.
MDE-4624C CFN Series Tokheim® Pump PC Interface for CFN III with Windows
NT® or XPE · January 2011
Gilbarco ® is a registered trademark of Gilbarco Inc . Tokheim ® is a registered trademark of Tokheim Group S.A.S. Unitec ® is a registered
trademark of Unitec Electronics. Windows ® XP and Windows NT ® are registered trademarks of Microsoft Corporation.
Configuration Technical Debug Options
Debug Log File
All the log files are in the subdirectory named: c:\SC3\TOK_log. Each debug log file is saved
as TOK_log.cxx, where:
c = COMM port number
xx = cycles from 00 to 99, then 00 over again
Press f when you start for the first time on COMM 1. The logging will go to:
TOK_log.100 for 1 Meg of data, then to
TOK_log.101 for another 1 Meg, then
.
.
.
TOK_log.199 for another 1 Meg, then
TOK_log.100 and cycles through again.
It is possible to log in to two sessions at one time. For COMM 2, the file will start at
TOK_log.200 following the same format as COMM 1.
If you restart the Tokheim pump session, it starts with the next file after the last one that was
written. For example, if you quit (ALT-X) during TOK_log.123 and start over, or restart
(ALT-R) and turn on file logging again, it will begin with TOK_log.124.
If you see an event you want to capture, press ALT-R (then press f again if you want to
continue with logging, which will start a new log file). You can then remove or copy the old
file.
Example of TOKPUMP.Axx File
Note: The following file is for illustration purposes only. The files will differ depending on
your specific site requirements.
Figure 3-5: TOKPUMP.Axx File