Figure 14, Caution – Gasboy 03908X User Manual

Page 17

Text mode
Original mode

MDE-4351A Gasboy ATC Kits 039086 and 039087 Installation Manual • February 2006

Page 17

Installation

Figure 14: Mounting the IS Barrier on the Shelf

Place the wires extending from the mounting stud through the mounting hole in the dual probe
connector assembly and place the connector assembly up on the stud (underneath the shelf).

Place the washer and nut over the wires and turn nut onto the stud securing the IS barrier and
probe connector. Tighten snugly but do not overtighten.

Place the wires extending from the top of the IS barrier up through the grommet in the upper
shelf as shown in

Figure 15

IS Barrier

Probe Connector
Assembly

Notch in Shelf

If your kit contains the newer version of the 218Y00 IS Barrier (see

Figure 1

for

identification) and your unit does NOT have the notch in the shelf (

Figure 14

), the IS

barrier will not mount. DO NOT try to mount the IS barrier if the shelf does not have the
notch.

CAUTION